N49 W13650 Campbell Drive
Menomonee Falls, WI 53051
Phone 262.783.3500
Toll-Free Phone 800.288.8178
Canada
Toll Free Phone: 800.792.7253
Fax: 905.8281526
For service or technical
information contact:
1.866.MAG.SERV
(1.866.624.7378)
Outside the U.S. &
Canada call
1.262.783.3500, press 3
www.columbusmckinnon.com/magnetek
© Copyright 2021 Magnetek
DataLogger Series 4
Quick Start Guide
144-27098 R1
February 2021
1. Connect to IMPULSE
®
•G+ Mini, Series 3, or Series 4 VFD
The DataLogger Series 4 (DLS4) may be placed directly into the keypad
holder on the Series 4 drive. Alternatively, use the supplied Ethernet (CAT5)
cable. Plug one end into the RJ45 port on the drive and plug the other end
into the RJ45 port on the back of the DLS4.
Reference the technical manual for additional information.
2. Set the Date & Time
•
Navigate to the DataLogger Settings menu and press
.
•
Scroll to the Set Date/Time menu and press
.
•
Choose a value to change and press
. The current value will blink.
•
Use the
and
keys to choose a desired value and then press
to accept.
NOTE: To leave any menu or cancel an action, press
.
3. Read and Write Parameter Sets
•
Navigate to the Parameter Backup menu and press
.
•
To read from a drive and store a parameter set, press
labeled “READ”.
•
To confirm and begin the read, press
labeled “YES”.
•
To write parameters from the DLS4 to a drive, press
labeled “WRITE”.
•
To confirm and begin the write, press
labeled “YES”.
4. View Run, Fault, and Alarm History
•
Navigate to the Event History menu and press
.
•
Press
on the desired menu and press
or
to cycle through the history log.
•
Press
or
to scroll through additional associated information.