51839925_V_1_3.DOC
51/102
b) Editing via the external controller
•
Call up the first scene in your controller now.
• Select
“SC01”
by pressing
[UP]
or
[DN]
.
• Press
[MODE/ENTER]
, the display shows
“SC01”
.
• Press
[MODE/ENTER]
, the display shows
“C-01”
.
• Select
"CNIN"
by pressing
[UP]
or
[DN]
.
• Press
[MODE/ENTER]
, the display shows
"OFF"
.
• Press
[UP]
, the display shows
"ON"
.
• Press
[MODE/ENTER]
, the display shows
"SC02"
. You successfully downloaded the first scene.
• Adjust the Step-time as described above.
•
Call up the second scene in your controller now.
• Repeat steps 5-11 until all desired scenes are downloaded.
• Press
[EXIT]
to exit. The number of steps can be defined under
“STEP”
and the scenes can be called up
under
“RUN”
Error Messages
When you turn on the fixture, it will make a reset first. The display may show “XXEr” while there are
problems with one or more channels. “XX” stands for the channels equipped with a testing sensor.
For example, when the display shows “04Er”, it means there is some error in channel 4. If there are
some errors on channel 4, channel 5, channel 6 at the same time, you may see the error message
“04Er”, “05Er”,”06Er” flash repeatly for 5 times, and then the fixture will generate a reset signal, all
the stepper motors will reset. If the error messages maintain after performing reset more than 3
times, it will detect whether the fixture has more than 3 errors. If the fixture has more than 3 errors
(including 3 errors), all the channels can not work properly; but if the fixture has less than 3 errors,
only the channels which have errors can not work properly, others can work as usual.
04Er:
Color-wheel error. This message will appear after the reset of the fixture if the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepping-motor is defective (or its drive circuit on the
main PCB). The color-wheel is not located in the default position after the reset.
05Er:
Static gobo-wheel error. This message will appear after the reset of the ficture if the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepping-motor is defective (or its drive circuit on the
main PCB). The static gobo-wheel is not located in the default position after the reset.
06Er:
Rotating gobo-wheel error. This message will appear after the reset of the fixture if the magnetic-indexing
circuit malfunctions(sensor failed or magnet missing) or the stepping-motor is defective (or its drive circuit on
the main PCB). The rotating gobo-wheel is not located in the default position after the reset.
07Er:
Rotating gobo indexing error. This message will appear after the reset of the fixture and if the magnetic-
indexing circuit malfunctions (sensor failed or magnet missing) or the stepping-motor is defective (or its driver
circuit on the main PCB). The rotating gobo is not located in the default position after the reset.
08Er:
Prism-wheel error. This message will appear after the reset of the fixture and if the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepping-motor is defective (or its driver circuit on the
main PCB). The prism-wheel is not located in the default position after the reset.
