51839925_V_1_3.DOC
35/102
Lamp adjustment
The lampholder is aligned at the factory. Due to differences between
lamps, fine adjustment may improve light performance.
Strike the lamp, open the shutter, set the dimmer intensity onto 100 %
and direct the light towards a flat surface (wall). Center the hot-spot
(the brightest part of the beam) using the 3 adjustment screws
"1, 2,
3”
. Turn one screw at a time to drag the hot-spot diagonally across
the projected image. If you cannot detect a hot-spot, adjust the lamp
until the light is even.
To reduce a hot-spot, pull the lamp in by turning all three screws
"1,
2, 3”
clockwise ¼-turn at a time until the light is evenly distributed.
If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back
in the reflector. "Push” the lamp out by turning the screws
"1, 2, 3”
counterclockwise ¼-turn at a time the
light is bright and evenly distributed.
Inserting/Exchanging gobos
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
CAUTION!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.
When installing metal gobos, please make sure that the mirror-inverted side points to the lamp. When
installing glas-gobos, please make sure that the coated side points away from the lamp.
Notes!
Slot-in gobo-system for exchanging gobos without tools!
Inserting/Exchanging gobos as described above.
