162
＜ Model Menu (Helicopter Functions) ＞
Pitch → Needle
This mixing is used when the engine is equipped
with needle control or other fuel-air mixture
adjustment. A needle curve can be set.
An acceleration function which temporarily
increases needle operation at throttle stick
Setting method
ŏ
When using this function, Tap [INH]. (ON is
displayed.)
ŏ
When you want to set the same contents at
other conditions, select the group mode.
When you want to set the selected condition
only, select the single mode (initial setting).
ŏ
A needle curve can be set.
ŏ
A switch can be set.
When [--] is set, the mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, tap
to the [--] item. Tap the screen to call the
selection screen and set the switch and its
ON position.
< Acceleration function setting>
ŏ
Acceleration can be set at both setting
at acceleration (high) and setting at
deceleration (low).
ŏ
The acceleration rate (rate) and the return
time after operation (damping) can be set.
ŏ
An operation point (Act position) at
acceleration and deceleration can be set.
When an operation point was exceeded,
acceleration operation is performed.
ŏ
Select [Pitch
ń
Needle] at the model menu and
call the setup screen shown below.
acceleration/deceleration operation can be set.
The rise characteristic of the needle servo at
acceleration and deceleration operation can be
adjusted.
● Mixing curve setting
*For a description of the
curve setting method,
see the description at
the back of this manual.
Normally, use [Point] type.
ŏ
Return to Model menu
