FUTABA CGY755, Руководство пользователя

Страница: 20 / 112

21
WARNING
Do not perform the linking procedure while the motor’s main wire con-
nected or the engine is operating as it may result in serious injury.
When the linking is complete, please cycle the receiver power
and ensure the receiver is properly linked to the transmitter.
Please power up your system in this order. Transmitter first, fol-
lowed by the receiver.
If the CGY760R was previously linked to another transmitter,
make sure that transmitter is not operating while linking the receiv-
er to the new transmitter.
Once the ESC is connected to the CGY, you need to complete all necessary transmit -
ter settings (ATV, EPA, REV, etc.) according to ESC instructions. Please refer to page
71 of this manual for further suggestions on the use of the governor of CGY760R/
CGY755 and the electric model.
Link Method With Transmitter (FASSTest / T-FHSS)
1. Connect the CGY760R and GPB-1 and set the same mode set in as the transmitter
linking the CGY760R communication mode on the "Receiver" screen. (See page 36)
2. Keep the transmitter and receiver close to each other and turn on the receiver with
the transmitter in the link mode.
3. After powering on the receiver, please allow for approximately two seconds for the
binding/linking to occur.
4. The LED indication on the receiver will change from the red blinking light to a solid
green. This indicates that the linking is successful. This usually occurs in approxi-
mately one second.
* Refer to the transmitters instruction manual for complete details on how to place
the transmitter into the linking mode.
* If there are many T-FHSS or FASSTest systems in use when attempting to link the
transmitter to the receiver, it might require more time to do so.
Additionally, if another modeler in close proximity is attempting to link their units
simultaneously, it could also cause difficulties as the receiver might inadvertently
link to the other transmitter. Always confirm that the receiver responds to the in-
put from the desired transmitter.
* If the System Type of the transmitter is changed, the receiver will need to be re-
linked to the transmitter. For example, if the transmitter is changed from T-FHSS
to FASSTest, it will be necessary to perform the linking procedure once again.
For CGY760R