75
(3) CNT. DlIn: Control delay in
This parameter sets the delay as you move the stick from neutral toward
left or right. Larger values result in a softer tail rotor feel off center. This
parameter must be adjusted individually for LEFT and RIGHT tail rotor
commands. Hold the cursor to "CNT. DlIn" by pressing the [ /+] or [ /-]
key. Move the rudder stick to the left or right by amount the " "cursor
moves. Enter the setting mode by pressing the [Enter] key, adjust the
amount of delay with the [ /+] or [ /-] key, and then press the [Enter] key
to exit the setting mode. Follow these same procedures to adjust the tail
rotor feel in the opposite direction.
Setting ranges: 0 ~ 20 n Initial value: 15 n
(4) CNT. DlOut: Control delay out
This parameter sets the delay when the stick is returned back to the
neutral position. This parameter is useful to tune how aggressively the
tail rotor stops following a pirouette. The higher the value, the softer the
stop. This parameter must be adjusted individually for LEFT and RIGHT
tail rotor commands. The setting method is the same as "CNT. DlIn", so
please refer to the information above.
Setting ranges: 0 ~ 20 n Initial value: 12 n
RUD. EXPERT screen 2/5
From 1/5
Go to 3/5 from any cursor position
Содержание CGY755
Страница 112: ......
