Manual Introductory Section
WORKING WITH THE CAMPAC MEMORY MODULE
The optional CAMPac Memory Module can be
used to store model setup data separately from the
transmitter. Its advanced electronic design needs
no battery back-up power, so the CAMPac may be
used to transfer data directly into another PCM
1024Z system.
When the transmitter power switch is turned on
for the first time after the set is purchased, or
when the power switch is turned on after the
memory module has been changed, the "INI-
TIALIZE EXT MEM?" message will appear at the
center of the screen. Press the YES key to ini-
tialize the memory module so it is ready to store
data.
The CAMPac can store and memorize as many
as 16 sets of model data, depending on the number
of flight conditions. When used in conjunction
with the transmitter's 10-model memory, as many
as 26 different model setups may be permanently
stored. The table below gives the numbers of
model data that the CAMPac can store, which
depends on the number of flight conditions. When
power is turned on, it may take some time to copy
complicated model and flight condition data into
the transmitter's memory. This normally takes just
two or three seconds.
Number of flight conditions
1
2
3
4
5
6
7
8
Memorizable model data
16
9
6
5
4
3
3
2
Moving the CAMPac from one PCM 1024Z
transmitter to another is one way of transferring
model setups from the first to the second. Another
way may be used with transmitters that do not
have the CAMPac installed. This method requires
an optional data transfer cord.
Manual Introductory Section, Page 12
