FRQ—TRANSMITTER FREQUENCY SETTING
(9ZAPS/HPS ONLY)
System Section
The exclusive Frequency Synthesizer System
Module (FP-TK-FSS) allows you to switch your
transmission frequency in software! No longer do
you have to carry around a module and receiver
for each frequency, or a carton of crystals! You
may choose from any of the frequencies in the 72
MHz band, channel numbers 11 through 60
(72.010 to 72.990 MHz).
When you activate the FRQ function, the dis-
play shows the frequency list with channels 11
through 20 displayed. To display the next ten
channels, press the NXT (R)
key; to show the
previous ten channels, press the PRE (Q) key.
To select the transmit frequency, first locate
the desired frequency using the procedure above.
Then, select the desired channel number with the
channel selection keys A
to
J. It the selected
channel is the correct one, verify by pressing the
Set (O) key.
It is necessary to cycle the transmitter's power
to broadcast on the selected frequency. When you
do this, the channel number and frequency are dis-
played on the Home Screen. READ THE WARN-
ING BELOW BEFORE TURNING ON.
WARNINGI
Be sure that you know the frequency your trans-
mitter is set to broadcast on BEFORE you turn it
on. If you are unsure what the frequency is, hold
either the A or R keys and turn on the transmitter.
The transmit frequency will be displayed on the
Home Screen. Then, turn off the transmitter and
turn it on again when you have the proper frequency
control in your possession.
To View Next
10 Channels
To View Previous
10 Channels
Press if Incorrect
Channel Chosen
Use to Confirm
Channel Setting
Return to
System Menu
Use To Select Desired Channel No.
Displays the Selected Frequency
& Channel Number
System Section, Page 35
