Furuno FCV-38, Руководство по установке

Страница: 48 / 81

3. INITIAL SETTINGS
3-14
2. Select [Calibration] from the [External Echo Sounder] menu list.
The [Calibration] menu appears.
3. Set the calibration parameters from the list.
4. Select [OK] to close the menu.
External Echo Sounder mode is ‘On’
When an echo sounder is selected at [Connected Fish Finder] in the [External Echo
Sounder] menu, do the following settings for the external echo sounder.
1. Select the [Display] icon ( ) from the InstantAccess bar, and select the [Exter-
nal Sounder] icon ( ) from the expanded menu bar.
The external echo picture is displayed on the sub monitor.
Item Setting values Meaning
[Zero Line Rejection] [Off],
[On] (default)
Turn the zero line (transmission line) on
or off.
[Zero Line Area] [m]: 1.4 to 3.0
[ft]: 4.5 to 9.8
[fm]: 0.7 to 1.6
[HR]: 0.9 to 2.0
[pb]: 0.8 to 1.8
(The minimum value
is default.) Adjusts the transmission line. Refer the
figure below this table.
[Gain ADJ (HF)] [-50] to [50]
(default: [0]) Set the gain for high frequency of the
Satellite Compass.
[Gain ADJ (LF)] [-50] to [50]
(default: [0]) Set the gain for low frequency of the
Satellite Compass.
[TD fore-aft] [-100.0] to [100.0]
(default: [0.0]) Fore-aft distance (m) from antenna to
transducer. Enter a positive value for a
fore-side transducer.
[TD port-stbd] [-100.0] to [100.0]
(default: [0.0]) Port-starboard distance (m) from anten-
na to transducer. Enter a positive value
for a starboard-side transducer.
[ANT TD height] [0.0] to [100.0]
(default: [0.0]) Vertical distance (m) between the an-
tenna and the transducer.
FCV-38[ver 0252473-xx.xx]
FCV-38[ver 0252473-xx.xx]
Satellite Compass antenna
FORE (+) / AFT (-) FORE (+) / AFT (-) FORE (+) / AFT (-)
Transducer Transducer Transducer
PORT(-) PORT(-) PORT(-)
Transducer
[Height] [Height] [Height]
STBD(+) STBD(+) STBD(+)