ATR833S / P/N 833S-(Cxxx)-(Cxxx)
Operation and Installation
12
Document-Nr.: 01.142.010.71e / Revision:1.03
When having the channel selection configured for 8.33 kHz steps
(see 3.1), the frequency input is in three steps:
2.4.3 Recall a Frequency from the User Memory
To access the user memory frequency list, press
MEM
once, and select
one of the 20 memory entries with the
VOL/SEL
turn knob.
The selected memory entry substitutes the former standby frequency.
In the upper line of the display, the number of the memory entry selected
is indicated by [MEM xx] (with xx = 00 to 19); if a name has been
provided by the user for this memory entry, it is displayed instead of the
memory number.
In order to speed up the entering of new frequencies, it is
possible to configure the radio to allow entering only those
frequencies that are used with 25 kHz channel width.
Please refer to chapter 3.1 for information on this
configuration.
However, when choosing this option, please keep in mind to
re-enable 8.33 kHz channel selection before flying into areas
where 8.33 kHz channels are used.
