Full Spectrum Laser MUSE MOPA, Руководство пользователя

Страница: 7 / 57

The power supply is capable of releasing a current up to 9 Amps. This power is sent to the discharge
terminals on the machine itself. In order to prevent access to bare wiring your laser shipped with
silicone terminal covers. Please notify Full Spectrum Laser support and immediately cease
operations if the covers ever slip and expose bare wire.
Compliance Statement:
The standard for laser safety is the American Standard for the Safe Use of Lasers, Z136.12000. Developed by the
American National Standards Institute (ANSI) it is the basis for many federal regulations and Occupational Safety
and Health Administration (OSHA) guidelines for laser and laser system manufacturers. It contains detailed
information concerning the proper installation and use of laser systems. While the ANSI standard is not a law, its
recommendations, including warning signage, training, and the designation of a laser safety officer, may be
mandatory under local regulations. It is the operator's responsibility to ensure that the installation and
operation of the Full Spectrum Desktop Laser System are performed following applicable laws. Copies of ANSI
Standard Z136.12000 are available from:
LASER INSTITUTE OF AMERICA 12424 RESEARCH PARKWAY, SUITE 125 ORLANDO, FL 32826 (407) 3801553.
Electrical Safety
Section I. Safety
Note: When performing any replacement procedures, make sure the machine is off for at least an hour.
● Do not open any of the machine’s access panels while the unit is plugged in.
● Never make or break any electrical connections to the system while the unit is turned on.
● Never access any electrical areas with hands or tools unless the unit is disconnected from the power
for at least one hour.
● Never replace the installed amp fuse with one of a higher rating.
● POWER ON/OFF is controlled by the switch at the back of the machine, with (-) being on and (o)
being off.
● In case of a blown fuse always contact Technical Support before replacing anything.
6