Fujitsu Primergy TX300 S4, Руководство пользователя

Страница: 247 / 276

247
PRIMERGY TX300 S4 User’s Guide
6
Perform the settings as required, and click [Next].
The restoration settings completion window appears.
7
Click [Finish].
The restoration start window appears.
8
Check the checkbox, and click [OK].
System restoration starts.
After the restoration has completed, the system is automatically rebooted. After rebooting, the
system is restored using the backup data.
`
For operation with a BitLocker drive encryption set, perform the encryption settings again after
the system restoration.
8.6.2 For Windows Server 2003
For Windows Server 2003, only system files, system configurations, and environment changes during
startup can be restored by using Automated System Recovery (ASR) set.
z
Items required
• Windows Server 2003 CD-ROM
• Automated System Recovery (ASR) floppy disk (created beforehand)
• Backup media (created beforehand)
• Driver disk (for an array controller)
For drivers to be used and how to create driver disks, refer to "4.4 Creating Maintenance Tools and
Driver Disks" (
J pg.91).
1
Turn on the server, and insert the Windows Server 2003 CD-ROM immediately.
Check there are no floppy disks in the floppy disk drive.
2
When the active area is specified on the hard disk, the following message
appears. Press any key while this message is displayed.
Setup window for Windows Server 2003 appears.
3
The following message appears at the bottom of the window. Press the [F6]
key.
`
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
Press any key to boot from CD....
Press F6 if you need to install a third party
SCSI or RAID driver ...