Fujitsu Primergy TX120, Руководство пользователя

Страница: 237 / 263

237
PRIMERGY TX120 User’s Guide
9
Op
eration
a
nd
Mainten
ance
9.6 Restoring the System
In the unfortunate event where the system file, system configuration, or environment
changes during startup are corrupted, use the repair information stored on the
recovery disk created at the installation to restore the system.
` Create a recovery disk when you have installed an OS or changed the system configuration. Refer to
"5.2 Creating a Disk for System Recovery" (
J
Pg.129).
` If the procedures of restoring the system are described in the manual of the backup devices or
Readme.txt of the device drivers, refer to these procedures.
z
Items Required
• Windows Server 2003 CD-ROM
• Automated System Recovery (ASR) floppy disk (created beforehand)
• Backup media (created beforehand)
• Driver disk (for an onboard array controller / for an array controller card)
For details about required driver disk and how to create a drive disk, refer to "4.1 Creating Driver
Disks" (
J Pg.106).
1
Turn on the server and insert the Windows Server 2003 CD-ROM immediately.
Check there are no floppy disks in the floppy disk drive.
2
When the active area is specified on the hard disk, the following message
appears. Press any key while this message is displayed.
Setup window for Windows Server 2003 x64 appears.
3
The following message appears at the bottom of the window. Press the [F6]
key.
`
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
4
When a message prompts you to press the [F2] key, press the [F2] key.
A message prompts you to insert the ASR floppy disk.
5
Insert the ASR floppy disk and follow the window instructions.
Press any key to boot from CD....
Press F6 if you need to install a third party
SCSI or RAID driver ...