Fujitsu PRIMEPOWER 800, Руководство пользователя

Страница: 71 / 145

C120-E093-04EN 43
5.2 Panel Operations
• Description of commands for setup
l
Segment ID
The segment ID is a (numeric) identifier to be specified for control of the main unit by the
SMC. An ID is to be specified for each main unit. All main units having the same ID
number can be controlled in the RCI network.
l
Server ID
The Server ID is a particular ID (a numeric value) that is required to register for controlling
multiple main units installed in one segment.
l
Altitude
The altitude is required to be set because the permissible operation temperature depends on
the altitude of the site where the main unit is installed.
5.2.3 Panel Operation (Example of Partition Startup)
Refer to the following partition startup example steps to understand this specific panel operation.
• Initial state
s
Messages are displayed on the Message Area, but the Message Area may be left in blank.
1
Press the Cursor switch. Move the cursor to the partition number you want to
select.
While the Cursor switch is pressed down, the cursor goes to right edge, then back to left edge.
2
Press the Decision switch.
The display changes to the command screen.
Setup must only be done by trained customer engineers. Correct setup of the following
commands is critical for proper operation.
! "!#$#!%
! "
!
"
#$%$ %&&%'