Fujitsu MPG3102AH, Руководство по эксплуатации продукта

Страница: 58 / 195

C141-E112-01EN 4 - 11
4.6.3 Read circuit
The head read signal from the PreAMP is regulated by the variable gain amplifier (VGA) circuit.
Then the output is converted into the sampled read data pulse by the programmable filter circuit
and the adaptive equalizer circuit. This clock signal is converted into the NRZ data by the 48/52
GCR decoder circuit based on the read data maximum-likelihood-detected by the Viterbi detection
circuit, then is sent to the HDC.
(1) VGA circuit
The VGA circuit automatically regulates the output amplitude to a constant value even when the
input amplitude level fluctuates. The VGA output is maintained at a constant level even when the
head output fluctuates due to the head characteristics or outer/inner head positions.
(2) Programmable filter
The programmable filter circuit has a low-pass filter function that eliminates unnecessary high
frequency noise component and a high frequency boost-up function that equalizes the waveform
of the read signal.
Cut-off frequency of the low-pass filter and boost-up gain are controlled from each DAC circuit in
read channel. The MPU optimizes the cut-off frequency and boost-up gain according to the
transfer frequency of each zone.
(3) FIR (Digital Finite Impulse Response Equalization Filter) adaptation circuit
The FIR provides support for changing equalization needs from head to head and zone to zone.
The FIR is a specialized digital filter with ten independently controlled coefficients.
(4) Viterbi detection circuit
The Viterbi detection circuit demodulates data according to the survivor path sequence.
(5) Data separator circuit
The data separator circuit generates clocks in synchronization with the output of the adaptive
equalizer circuit. To write data, the VFO circuit generates clocks in synchronization with the
clock signals from a synthesizer.
(6) 48/52 GCR decoder
This circuit converts the 52-bits read data into the 48-bits NRZ data.