ix
Safety notes
Screen/touchscreen (for devices with
integrated screen)
•
If the LCD panel or touchscreen is damaged
(e.g. glass broken), do not allow any escaping
liquid to come into contact with skin, mucous
membranes (eyes, mouth) or foodstuffs. Do
not inhale vapours. Clean parts of the body
and clothing that have already come into
contact with such liquids with plenty of soap
and water.
•
You may set only those resolutions and
refresh rates specified in the operating
manual for the device or in the operating
manual for the monitor. Otherwise you may
damage your monitor. If you are in any doubt,
contact your sales outlet or our Hotline/Help
Desk.
•
To prevent the device from overheating, the
LCD panel must be in its open position when
the device is on.
Connecting headphones
•
Excessive volume from headphones can
damage your hearing.
•
It is best for your hearing if the equalizer
settings are set to the mid-position. Settings
other than the mid-position can cause hearing
damage.
•
There are other factors beyond the control
of the manufacturer which can change the
output voltage at the headphone connection
and thus increase the headphone volume
(including e.g. the operating software,
equalizer software, drivers etc.). In such a
case the risk of hearing damage cannot be
excluded.
•
Only use headphones recommended by
Fujitsu. Otherwise there is a risk of hearing
damage due to excessive volume.
System expansions and accessories
•
Install only system expansions that satisfy the
requirements and rules governing safety and
electromagnetic compatibility and relating
to telecommunications terminal equipment.
If you install other expansions, you may
damage the device or violate the safety
regulations and regulations governing RFI
suppression. Information on which system
expansions are suitable can be obtained from
your sales outlet or our hotline/help desk.
•
Data cables for peripherals must be
adequately shielded to avoid interference.
•
The devices are only designed for indoor
LANs. In the case of an external LAN feed, a
LAN switch must be used to connect the LAN
to the devices.
•
The warranty is invalidated if the device
is damaged during the installation or
replacement of system expansions.
•
If the device is equipped with both a RJ-11
modem connection and an RJ45 network
connection with the identical appearance,
connect the telephone cable to the RJ-11
modem connection (and not to the RJ-45
network connection).
•
PC cards can become quite warm during
operation. Proceed with caution when
removing PC cards.
Additional information on system
expansions and accessories for
stationary devices
•
Before opening the device first switch it off
and then disconnect the power plug. Observe
the specifications in the device instructions.
•
The components (e.g. power supply) marked
with a warning sign (e.g. lightning sign) may
only be opened, removed or exchanged by
authorised, qualified personnel.
•
Make sure that you also switch off the
attached monitor and/or other peripherals
when you switch off the device.
0_AmiloMini_M1010_Intr_EN.indd 9
9/8/08 1:18:22 PM
