vii
Safety notes
•
For devices with a battery: improper
replacement of the device’s battery will result
in a danger of explosion. The battery may
only be replaced by an identical sort or by a
sort recommended by the manufacturer (see
device instructions).
•
Do not use damaged cables (damaged
insulation, bare wires). A damaged cable
presents a danger of electrical shock or fire.
•
If necessary, replace the original power cable
with a regular grounded 3-core mains lead.
•
If no suitable power cable was supplied with
the device, purchase an approved power cable
in your country. The voltage and amperage for
which the cable is suited must be higher than
the voltage and amperage indicated on the
product.
Additional information on the power
supply for devices with external mains
adapter and/or battery
•
Only the specified rechargeable battery and
the supplied mains adapter may be used
to power the device. You can find more
detailed information in the operating manual
of the device. Use only mains adapters and
rechargeable batteries approved by Fujitsu
for your device.
•
The battery is not waterproof! Never immerse
the battery in water and always protect it from
splashes of water (rain, sea spray).
•
If handled incorrectly, batteries may cause
hazards such as fire. Never therefore open,
pierce or compress a battery.
•
Never throw a battery into a fire (danger of
explosion!).
•
Take care not to drop the batteries or
otherwise damage their casing (fire risk). If
rechargeable batteries develop a fault please
stop using them immediately. Do not touch the
contacts of the batteries. Never interconnect
the positive and negative terminals of a
battery.
•
If a battery is leaking, avoid contact between
the liquid and your skin, mucous membranes
(eyes, mouth) or foodstuffs and do not inhale
the vapours. Clean parts of the body that have
already come into contact with such liquids
with plenty of soap and water.
•
Keep batteries out of reach of children.
•
If a lithium battery (button cell) is installed in
the device for real-time buffering, please note
that: The lithium battery may only be replaced
by authorised, specially trained personnel.
•
To disconnect the device from all power
sources, switch off the device, disconnect
the mains adapter from the electrical outlet
and remove all batteries from the battery
compartment and module slot.
•
Make sure that the rated current of the mains
adapter is not higher than that of the power
system to which you connect the mains
adapter (see technical data of the mains
adapter).
Installation and Operation
•
Ensure that the device is connected to a
mains socket with earthing contact and that
the device is close to the socket.
•
We recommend that you place your device
on an insensitive, non-slip surface. In view
of the multitude of different finishes and
varnishes used on furniture, it is possible that
the rubber / plastic feet will mark the surface
they stand on.
•
Never place the notebook and the mains
adapter on a heat-sensitive surface.
•
If the device is brought from a cold environment
into the operating room, condensed water
can form. Before operating the device, wait
until it is absolutely dry and has reached
approximately the same temperature as the
installation site.
•
Lay the cables in such a way that they do
not create a hazard (danger of tripping)
and cannot be damaged. When connecting
cables, follow the relevant instructions in the
device manuals.
0_AmiloMini_M1010_Intr_EN.indd 7
9/8/08 1:18:21 PM
