Fujitsu Lifebook S2110, Руководство пользователя

Страница: 54 / 120

46
L i f e B o o k S 2 0 0 0 N o t e b o o k
Memory Upgrade Module
Your Fujitsu LifeBook notebook comes with a minimum
of 256 MB of high speed Double Data Rate Synchronous
Dynamic RAM (DDR 333 SD-RAM) factory installed. To
increase your LifeBook notebook’s memory capacity (up
to a maximum of 2 GB), you may install a larger and/or
an additional memory upgrade module. The memory
upgrade must be a dual-in-line (DIMM) SDRAM
module. To ensure 100% compatibility, purchase the
SDRAM module only from the Fujitsu web store at
http://www.computers.us.fujitsu.com
.
INSTALLING MEMORY UPGRADE MODULES
1. Turn off power to your LifeBook notebook and
remove any power adapter (AC or auto/airline).
2. Make sure that all the connector covers are closed.
3. Turn the notebook bottom side up, and remove the
screws of the memory upgrade module compart-
ment.
(Figure 4-11)
4. Remove the cover.
Figure 4-11. Opening the Memory Upgrade Compartment
5. Remove the memory upgrade module from the
static guarded sleeve.
6. Align the memory upgrade module with the part
side up. Align the connector edge of the memory
upgrade module with the connector slot in the
compartment.
7. Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly down
and into the connector until it lodges under the
retaining clip. You will hear a click when it is prop-
erly in place.
(Figure 4-12)
Figure 4-12. Installing a Second Memory Module
8. Replace the cover. (Figure 4-13)
9. Replace the screws.
Figure 4-13. Replacing the Memory Compartment Cover
TO REMOVE A MEMORY UPGRADE MODULE
1. Perform steps 1 through 4 of Installing a Memory
Upgrade Module.
2. Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3. While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your notebook.
(Figure 4-14)
■ Do not remove any screws from the
memory upgrade module compartment
except the ones specifically shown in the
directions for installing and removing the
memory upgrade module.
■ The memory upgrade module can be
severely damaged by electro-static dis-
charge (ESD). Be sure you are properly
grounded when handling and installing
the module.
The memory upgrade module is not
something you routinely remove from
your notebook. Once it is installed, you
can leave it in place unless you want to
change system memory capacity.
S Series.book Page 46 Thursday, June 2, 2005 3:28 PM