Fujitsu Lifebook B112, Руководство пользователя

Страница: 50 / 174

S e c t i o n T h r e e
36
If your notebook is suspended, pushing the
Suspend/Resume button will return your note-
book to active operation at the point where it
went into suspension. You can tell whether or
not your system is in Suspend mode by looking
at the Power indicator. (See page 20.) If it is visi-
ble and not flashing, your notebook is fully
operational. If it is visible and flashing, your
notebook is in Suspend mode. If it is not visi-
ble, the power is Off or your notebook is in
Save-to-Disk mode. (See pages 37-38.) When
you receive your LifeBook B112 it will be set to
the default, which is Suspend mode. Suspend Mode
The Suspend mode, or Standby mode in
Windows 98, saves the contents of your note-
book’s system memory during periods of inac-
tivity by maintaining power to critical parts
while turning off the CPU, the display, the hard
drive and all other internal components except
those necessary to maintain system memory,
recognize the Suspend/Resume button and
restart. Your notebook can be put in Suspend
mode by:
■
Pressing the Suspend/Resume button when
your system is in the On state.
■
Selecting Standby from the Windows Shut
down menu.
■
Timing out from lack of activity.
■
Battery level reaching the Dead Battery
Warning condition.
Your notebook’s RAM typically stores the file(s)
on which you are working, the open applica-
tion(s) and any other data required to support
the operation(s) in progress. When you resume
operation from Suspend mode, it returns to the
point in the operation where it left off. You
must use the Suspend/Resume button to
resume operation, and there must be an
adequate power source available, or your
notebook will not resume.
Using the Suspend/Resume Button to
Perform Save-to-Disk
When your notebook is active, the Suspend/
Resume button, (Figure 3-13), can be used to
manually put your notebook into Save-To-Disk
mode. However, you must first enable Save-to-
Disk mode:
■
For Windows 98 you must enable Save-
to-Disk mode in the BIOS Setup utility
Power menu. (See pages 83-90 for more
information on the Power menu of the
BIOS Setup utility.)
Push the Suspend/Resume button, when your
notebook is active but no Access indicators are
on and release the button (immediately). You
will hear two short beeps and then your system
will flash the Save-to-Disk screen, and enter
Save-to-Disk mode.
C A U T I O N
Loss of all power sources, including
batteries, while in Suspend mode will
cause loss of data and an inability
to return to operation with the
Suspend/Resume button.