Peak cut mode
By performing following on-site work, operation that suppresses the current value can be enabled:
The air conditioner is set to the “Peak cut mode” when closing the contact input of a commercial
timer or on/off switch to a connector on the control PCB of the outdoor unit.
•
Circuit diagram example (CN132)
Outdoor unit
control PCB
Connected unit
Example: Switch
Signal
*10 m
Connector
Locally purchased
CN132
• Contact capacity: DC 24 V or more, 10 mA or more.
• *: Make the distance from the PCB to the connected
unit within 10 m.
• Construct a circuit as shown in this figure with using op-
tional parts mentioned below.
• Input signal: On in “Peak cut mode”
• Input signal: Off in normal operation
• To set the level of “Peak cut mode”, refer to
On
Off
On
Off
Input signal
Peak cut mode
•
Optional part
Part name
Model name
Exterior
External connect kit
UTY-XWZXZ3
- 233 -
6-2. Outdoor unit
6. External input and output
SYSTEM
DESIGN
SYSTEM
DESIGN
Содержание AUYG18LVLB
Страница 151: ...Part 2 OUTDOOR UNIT SIMULTANEOUS MULTI AOYG72LRLA AOYG90LRLA ...
Страница 181: ...Part 3 SYSTEM DESIGN ...
Страница 333: ...Part 4 OPTIONAL PARTS ...