26
4. SETUP AND MAINTENANCE
4
4.3.6 Custom Setting Regist/Delete (0225)
Printing is normally performed with condition of the Master “0”
channel.
The 65 (0 + 64) custom conditions can be set up for each input
type.
The custom conditions can be selected on the “Process 1” screen
(see the “Operating Instructions” manual).
[Selection]
[Setup and Maintenance]
→
[02 Print Condition Setup and
Check]
→
[0225 Custom Setting Regist/Delete]
[Procedure]
Set up the custom conditions.
1. Select the input type to be set up.
Input Type: Negative
Reversal
Black & White Negative
2. Select the number to be set up.
3. Enter the name for the back printing of custom setting in the
“Name” box using the full keyboard.
4. Click the [Cond. Edit] button.
• The “Initial Value Selection” dialog box appears.
5. Select the number to be used as the initial value.
6. Click the [OK] button.
●
Input Type: Negative
• The “1. Corr. Level/Tone/Hypertone” screen appears.
1) Set up the “Correct Level”, “Tone Adjustment” and
“Hypertone”.
<Correct Level>
<Tone Adjustment>
Standard
All Hard
All Soft
Highlight Hard
Highlight Soft
Shadow Hard
Shadow Soft
<Hypertone>
Hypertone Process: Yes
No
Highlight Level:
Lower
Low
Normal
High
Higher
Shadow Level:
Lower
Low
Normal
High
Higher
Mode:
Mode 1
(Normal Hypertone
Mode)
Mode 2
(Preceding acceptance
rate by improving
backlighting and
increasing contrast)
Tone Correction
Color/Density Correction
Hypertone
Full Correction:
Yes
Yes
ON
Tone Fixing:
No
Yes
OFF
L-CORR:
(Low Correction)
OFF
Condition Confirm:
No
No
OFF
4.3.6
SP3000_instruct_E.book 26 ページ ２００７年１２月１１日 火曜日 午後１時６分
