Fuji Xerox DocuPrint M218 fw, Руководство пользователя

Страница: 134 / 468

133 Printer Connection and Software Installation
• Using Ad Hoc Connection
To configure the wireless settings for an ad-hoc connection where the wireless devices communicate
directly with each other without an access point:
1
On the operator panel, press the System button.
2
Select
Admin Menu
, and then press the button.
3
Select
Network
, and then press the button.
4
Select
Wireless Setup
, and then press the button.
5
Select
Manual Setup
, and then press the button.
6
Enter the SSID, and then press the button.
Use the numeric keypad to enter the desired value, and press the or button to move a
cursor.
7
Select
Ad-hoc
, and then press the button.
8
Select an encryption type, and then press the button.
IMPORTANT:
• Be sure to use one of the supported encryption methods to protect your network traffic.
9
Enter the WEP key, and then press the button.
Use the numeric keypad to enter the desired value, and press the or button to move a
cursor.
10
Select a transmit key.
11
Wait a few minutes until the printer restarts to establish the wireless network.
12
Print a System Settings page from the operator panel.
See
"Printing a System Settings Page" on page 188 .
13
Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
Auto Setup With the Access Point
If the access point such as a wireless router supports the WPS, security settings can be made
automatically.