MT6M16534
© Fuji Electric Co., Ltd. All rights reserved.
• The products are packaged in tubes that are pinned at both ends.
• Remove the pin on one side to pick out the product from the tube.
• If the pin and the product are in contact with each other when removing the pin, a strong impact
might be applied to the product, which may cause deformation or damage to the product terminals.
Make a gap between the pin and the product when removing the pin.
• The recoil of removing the pins may cause deformation or damage to the terminals of the product,
so remove the pins with holding them.
• If the product falls out from the tube when removing the pins, it may cause a strong impact to the
product, causing the product terminals to be deformed or damaged. Remove the pin with the tube
opening facing up.
• It is recommended to use a remover (removal jig) to remove the pins. The following shows how to
remove the pins using the remover.
• Pin removing method using remover (removal jig).
1.
Make a gap between the pin and the product. (See Fig. 2-1)
2. Precautions in unpacking
This chapter describes the precautions in unpacking for the product.
2-1
1
Removing the pin from the tube
2.
Push the pointed end of the pin with your index finger, and make a gap between the pin and the
tube to insert the remover removal part as shown in Fig. 2-2. (See Fig. 2-3)
Fig. 2-2 Example of remover (removal jig)
Fig. 2-3 Gap between the pin and the tube
Fig. 2-1 Gap between the pin and the product
GAP
Removal part
Gap
