FTE Maximal MAX S123 HD, Быстрое руководство по установке, Страница: 32 / 44

PAG. 32
rev 1.1
EN
GL
ISH
SYSTEM SETUP
“No” then even those channels can be selected without entering
the password first.
4. New menu password: The password of the installation menu
access can be modified You should do this after you set up
the receiver the first time and every time when you think that
your password is known by unauthorized persons. To change
the password, enter the new password in the “New Password”
item and repeat the same one in the “Confirm Password” item.
If the passwords are not identically then you will see a warning
message. If you entered the same new password in both fields
then you will see the message “Saving Data, Please Wait…”.
From now on you need to use the new password to open locked
menus or locked channels.
New channel password: The password of the channels access
can be modified.
NOTE: The password by default in both cases is “0000”
5. Press [Exit] to leave the “Parental Lock” menu.
5.6. POWER SETTING
When you select this option, you will see a screen like beside
(OSD 67):
1. Automatic standby: In this option you can program the
automatic turning off of the receiver (OSD 68).
The programming can be made after a period of time between 1
and 10 hours, with 1 h. intervals. The default time is 3 hours.
-On: The receiver will be in standby mode automatically after
this time, as long as during this time no commands have been
sent to the receiver through the remote control or buttons of
the front panel, and no programmed timers are run.
-Off: Auto standby function gets deactivated.
2. Standby mode: In this option you can select “with clock” (the
receiver shows the clock in the display in standby mode) or “no
clock“ (nothing is showed in the display in standby mode).
3. LNB Power: If your receiver is connected to the LNB directly
then you need to set the LNB Power to “On”. If your receiver is
connected to a multi switch (SMATV signal distribution system)
then it may be that you don’t need to provide the power to
the LNB. But since this is depending on the kind of installed
distribution system we recommend you to contact your installer
or to refer to the user manual of this system to get the correct
information.
You also just can change this setting and check if you still can
receive the channels. If the LNB Power is off and you still can
see all channels then we recommend this setting.
4. RF LOOP in standby: in this opcion you can enable “On”
or disable “Off” the signal loop in the IF OUT output when the
receiver is in standby mode.
5. Press [Exit] button to leave this menu.
OSD 68
OSD 67