FTE Maximal MAX S123 HD, Быстрое руководство по установке, Страница: 27 / 44

PAG.27
rev 1.1
EN
GL
ISH
4.7. TP SCAN
When you enter “TP Scan” menu a window like the one beside
will be displayed (OSD 50):
1. On “Satellite” item, press [
] to select the satellite you
want to scan or press [OK] to open the satellite list for selection.
2. On “TP Index” item use [
] to select the desired
transponder.
If any of the TP of the list have tuned and stored channels into
the receiver, the following three options “Frequency”, “Symbol
Rate” and “Polarity” will not be able to be edited.
It means that the parameters cannot be modified by error
neither loosing the stored channels when any value of the data
base is changed.
In case of any value, for example the Symbol Rate of a TP,
has been modified by the provider and the receiver has these
channels tuned, the TP must be deleted (it will delete all the
channels of this TP), create it again with the correct data, and
to carry out a new search of the TP.
In this item you can also add TP.
- Press [Red] button to add a new TP (OSD 51). You have to
set the parameters of “TP Frequency”, “Symbol Rate” and
“Polarity” for this new transponder. Therefore use the number
buttons of the RCU. The available range are “3000~13450
MHz” and “1000~45000KS/s”.
For transponders you also can use number buttons to modify the
parameters of “TP Frequency” and “Symbol Rate” or [
] to
change the value directly. “Polarity” and “Scan Mode” are used for
setting scans conditions. Press [
] to select a different mode.
Polarity: Press [ ] to switch between “Auto / H / V”.
3. Press [OK] to start scanning.
4. On the “TP Scan” item, press [Exit] to cancel the scanning
and saving the found channels.
4.8. SATELLITE GUIDE
When you enter “Satellite Guide” menu, you will see the screen
like beside (OSD 52).
Here you can enter your local longitude and latitude and the
satellite’s longitude. The receiver calculates the antenna’s azimuth
and elevation to point your antenna to the selected satellite.
1. Use the [Number] buttons to input the values of “Local
Longitude”, “Local Latitude” and “Satellite Longitude”.
2. Press [
]buttons to select east or west in “Local
Longitude” and “Satellite Longitude” or to select north or south
in “Local Latitude”.
3. Highlight the “Start” item and press [OK]. In the lower part
of the window the corresponding values for the antenna setting
are displayed (OSD 63).
4. Orientation means the angle between south and satellite.
5. Press [Exit] to leave this feature
INSTALLATION
OSD 50
OSD 51
OSD 52