FSL3D Phoenix Touch, Руководство пользователя

Страница: 4 / 45

4
Printer Safety
● The reflected LED light of the projector is not harmful to the eyes, however it is not
recommended to run the printer with the yellow cover open.
● Do not open the printer case. This will void your warranty and could expose the user to
electrical shock.
● Do not block the printer air vents.
● Regularly clear air vents of all dust, dirt and other debris that might prevent or hinder
printer cooling.
Work Area
● The printer must be installed on a level surface to prevent spillage of resin. The resin
may spill out during the lift cycles if the surface is uneven.
● Keep a board nearby to use underneath the build head when removing prints. This will
prevent resin from dripping over the front of the printer.
● The printer must be installed in a location away from direct sunlight or intense artificial
light sources. These environments could prematurely cure your resin.
● To ensure resin flows properly, the work area should be kept between (15°C / 60°F) and
(26°C / 80°F).
● The printer itself emits no fumes and the resin contains zero volatile organic compounds.
However, Isopropyl Alcohol (IPA) is commonly used to finish prints so an area with good
ventilation is recommended.
Resin
FSL photopolymer resin is a mild irritant. Follow standard safety procedures and FSL handling
instructions.
● Only use resin from FSL or approved partners. Using 3rd party resin may damage your
machine and void your warranty.
● Wear protective gloves when handling the resin. Goggles are also recommended.
● Resin is not edible in liquid or solid form.
● Liquid and solid forms of resin are not approved for use with food or drink.
● Liquid and solid forms of resin are not tested or approved for use in medical applications.
● Do not mix the resin with any substances.
● The resin is light sensitive, so avoid long exposure to strong artificial lighting or sunlight.
The transparent yellow cover is designed to filter UV light, but strong exterior light may
enter and cure the resin. It is important that the unit be kept out of direct sunlight or
high­intensity artificial light.
● To avoid contamination, do not pour used resin back into the original bottle. It is safe to
store resin in the build tray for a period of 24hrs or less between prints. For periods
greater than 24 hours, we recommend to empty the build tray and to filter the resin.
Store filtered resin in a light­proof container.
[Main Menu]