FSL3D Phoenix Touch, Руководство пользователя

Страница: 28 / 45

28
Removing the Build Head
● When the model has finished printing, wait at least 10 minutes to allow excess resin to
drip back into the vat before opening the lid.
● Wear gloves when handling resin.
● Open the lid.
● Place a board over the SuperVAT™ before removing the build head to avoid resin drips
over the front of the machine.
● To remove the build head, loosen the large thumbscrew enough so the build head slides
out. You do not need to completely remove the screw.
● Remove the build head and transfer it to a safe location for cleaning.
● Always make sure to remove the build head before removing the SuperVAT™ liner.
Removing the resin tray first will expose the inner electronics of your printer to resin drips
from the build head.
● Close lid to protect the resin from external UV light.
Finishing Steps
Removing Your Model
● Use the edge of a steel paint scraper and wedge it underneath the print. Most prints can
be removed delicately. For stubborn prints, use a hammer or mallet to tap the end of
the scraper to help release your print. Be careful not to damage your build head.
Continue until the whole model is removed.
Rinsing Uncured Resin
● Fill your container with 99% Isopropyl Alcohol (IPA) and place your model inside. Let it
soak for 15 minutes to clean excess liquid resin. You may try holding the model with
tongs and swirling the model inside the container remove any loose resin. We
recommend you cover the container with a lid to prevent excessive evaporation of the
IPA.
● Clean the build head with paper towels or other paper wipes. You should clean the
platform right away after each print.
● Do not wash the SuperVAT™ with any chemicals. Cleaning the SuperVAT™ with
alcohol may cause it to crack. Wipe the SuperVAT™ clean with paper towels
● Take the model out of the IPA using the tongs after soaking.
[Main Menu]