Frymaster Rethermalizer FGP55, Инструкция по установке и эксплуатации, Страница: 26 / 28

3–9
3.9 FGP55 Computer Display Messages (cont.)
e
(four dashes) – Indicates that the water temperature is within the proper
rethermalizing range (i.e., within ±11
°
F of setpoint).
e
– Indicates that there is a heating problem. Call your local Factory Authorized
Service Center or the 24-Hour Hotline (1-800-551-8633).
e
– Indicates that the rethermalizer has detected a problem in the temperature control
circuits. Call your local Factory Authorized Service Center or the 24-Hour Hotline (1-800-
551-8633).
3.10 FGP55 Boil or Simmer Mode Options
In the Simmer Mode, the vessel temperature is maintained at the setpoint programmed by the
operator. In the Boil Mode, the vessel temperature is raised to 212
°
F (100
°
C).
Select the Simmer Mode by pressing the (R) button. If the temperature of the vessel is above the
setpoint,
°
-
will be displayed. If the temperature of the vessel is below the setpoint,
°
-
will
be displayed. If the temperature is within 11
°
F (6
°
C) of the setpoint, (four dashes) will be
displayed.
The Boil Mode is selected by pressing the (L) button. The computer will display and the
temperature of the vessel will be raised to 212
°
F (100
°
C).
See Section 2.6 for detailed boil-out instructions.
3.11 FGP55 Clock Display Options
The computer can be programmed to display rethermalizing time in minutes and seconds, or in hours
and minutes, depending on the product being rethermalized.
To toggle between display options, press the switch, enter
1 6 5 3
, then press the . To
determine which display is active, initiate a rethermalizing cycle by pressing a product button. If the
display is set to minutes and seconds, the time will immediately begin to count down. If it does not,
the display is set to hours and minutes.