Fronius MagicWave 1700 Job, Руководство по эксплуатации

Страница: 82 / 148

82
Job mode
General Job mode enhances the quality of welding engineering fabrication, both in manual and au -
tomated welding.
Up to 100 common jobs (operating points) can be reproduced in Job mode, avoiding the
need to document welding parameters by hand.
Another advantage is that the power source is immediately ready for welding with the de -
sired parameters. You can also arrange jobs in the order required by the production se -
quence. "Grouping" of jobs is also supported (e.g. by different components).
The result is to minimise downtimes while ensuring 100% reproducible quality.
Abbreviations The following messages may be displayed while working with jobs:
- - - ..... No job in this program location (job retrieval)
nPG ....No job in this program location (when saving a job)
PrG .... There is a job in this program location
Pro ..... Briefly displayed while job is being copied
dEL .... Briefly displayed while job is being deleted
Saving a job
NOTE!
Jobs are not created in the Job mode process.
Jobs can be created in the TIG AC welding, TIG DC welding and manual metal arc welding
processes.
The device comes with no jobs pre-programmed. To create a job, proceed as follows:
Set the desired welding parameters that you want to store as a "Job".
NOTE!
All the settings that are active at that instant will be stored.
Exception: Power source specific settings in set-up menu - level 2
Briefly press the Store button to switch to the Job menu.
The first vacant program location for the job is shown.
Select the desired program location with the adjusting dial, or leave the suggested pro -
gram location unchanged.
Press and hold the Store button
1
2
3
4