69
3.5.1 Install batteries
1. Remove the battery door on the back of the transmitter(s) by sliding down the battery
door, as shown in Figure 2 .
Figure 12: Battery installation for Multi-channel sensor
2.
BEFORE
inserting the batteries, locate the dip switches on the inside cover of the lid of
the transmitter.
3.
Channel Number:
The device supports up to eight sensors. To set each channel
number change Dip Switches 1, 2 and 3, as referenced in Figure
4.
Temperature Units of Measure:
To change the transmitter display units of measure
(°F vs. °C), change Dip Switch 4, as referenced in Figure .
Switch in down position. Switch in up position.
Figure 13: Dip Switch diagram
5. Insert two AA batteries.
6. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C)
are on the display.
Remove the battery door on the back of the transmitter(s) by sliding down the battery
channel sensor
inserting the batteries, locate the dip switches on the inside cover of the lid of
The device supports up to eight sensors. To set each channel
Figure .
To change the transmitter display units of measure
units of measure (°F vs. °C)
