68
3.3.7 Reset Button and Transmitter LED
In the event the sensor array is not transmitting, reset the sensor array.
Using a bent-open paperclip, press and hold the
RESET BUTTON
(see Figure 0) to affect a
reset: the LED turns on while the RESET button is depressed, and you can now let go. The LED
should then resume as normal, flashing approximately once every 16 seconds.
Figure 10: Reset button and Transmitter LED location
3.4 Indoor Sensor Set Up
Note:
To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
Remove the battery door on the back of the sensor. Insert two AA batteries.
Figure 11: Indoor sensor battery installation
3.5 Multi-channel temperature and humidity sensor (Optional)
The HP1000SE supports up to 8 additional thermo-hygrometer sensors (DP50), which can be
viewed on the display tablet and Internet.
Note
: Do not use rechargeable batteries. We recommend fresh alkaline batteries for outdoor
temperature ranges between -10 °C and 60 °C and fresh lithium batteries for outdoor
temperature ranges between -40 °C and -10 °C.