Fritsch PULVERISETTE 1 premium Series, Руководство по эксплуатации

Страница: 30 / 58

NOTICE!
Remove the zero point setting before you re-insert the
fixed clamping jaw. This prevents the gap from being
too narrow after the new crushing plates are installed
and prevents the crushing plates from being destroyed,
for example if ZrO
2
crushing plates are used. To remove
the zero point setting, see Chapter Ä Chapter 6.3.3
‘Checking the gap width’ on page 33.
11. Re-install the crushing jaw (13), insert the guide pin (2) and lock it
in place.
12. Close the lid (7)
13. Push in the source material container (8).
Using the device
- 30 -