Fritsch PULVERISETTE 1 premium Series, Руководство по эксплуатации

Страница: 32 / 58

7. Place the threaded spindle (b) with the cone in the bearing lifting
system.
8. Now push the crank (a) on to the brass square of the threaded
spindle (b).
9. Now push the crank (a) on to the brass square of the threaded
spindle (b).
10. After undoing the 3 cylinder-head screws (A) with the hex wrench
(c), you can lift off the clamping strip (20).
11. Take out the crushing plate (21).
12. Clean all parts in order that the crushing plate has even contact
during the installation.
13. Insert the replacement crushing plate or the old, turned crushing
plate (21) and screw the clamping strip (20) back on again.
14. Then turn the crank to move the crushing jaw (12) back into the
lower position.
15. Refit the guide pin (3). See also Ä Chapter 6.1.5 ‘Adjusting the
guide plate’ on page 26.
16. Remove the crank (a) and re-attach the pull plate with the
threaded spindle (b) to the retaining lug.
17.
Re-install the crushing jaw (13). See Ä Chapter 6.3.1.1 ‘Replacing
the crushing plate of the fixed crushing jaw’ on page 29.
Using the device
- 32 -