Page 18
Tiles
™
Installation Manual
Worksurface Installation
Page 18
Cantilever Bracket
Cantilever Bracket
Center Support
Center Support
Corner Bracket
Note: Corner worksurfaces should be installed
before installing adjacent worksurfaces
Corner Worksurfaces, and Extended
Corner Worksurfaces
1. Install Corner Bracket provided at the desired
height. Ensure all bracket hooks are fully
seated in slots.
2. Install Cantilever Bracket on Frame by insert-
ing the tab on the top hook of the Cantilever
Bracket into the Frame slot at the desired
height. Rotate bottom of Cantilever Bracket
into Frame to engage all hooks.
3. Repeat procedure for Cantilever on other side
of the Worksurface.
4. For Corner Worksurfaces 60” to 84” wide,
install Center Support on center Frame at the
same height as the Cantilevers on the right
and left side.
5. Push down on all worksurface supports to
ensure all hooks are fully seated in slots.
6. Install Shoulder Screws at the back of the
Worksurface in pre-drilled holes. Do not
install Front Spacers yet.
7. Install Worksurface on the Cantilever Brack-
ets (one side at a time) by inserting shoulder
screws into keyhole slots in rear of Cantilever
Brackets. Push Worksurface back until the
Front Spacers’ pre-drilled holes align with
holes in the Cantilever Brackets.
8. Install Front Spacers.
9. For Worksurfaces 60” wide or greater, align
Center Support Tab with pilot hole in under-
side of the worksurface. See picture at left.
10. Level Worksurface by adjusting the leveling
screw at the front of the Cantilever Brackets.
11. Install adjacent Worksurfaces as required.
12. Attach ganging plates between adjacent
Worksurfaces.