Install 168-pin DIMM modules in any combination as follows:
168-Pin DIMM Modules Memory Configuration.
2.2.5 Clear CMOS and Password
If your system can not boot up because you forget your password, or
the CMOS settings need to be reset to default values after the system
BIOS has been updated, the following instructions can be performed
to clear the CMOS and password.
1. Power off the system
2. Place a shunt to short pin2 and pin3 of JP9 for 5 seconds
3. Put the shunt back to pin1 and pin2 of JP9
4. Power on the system
2.2.6 Auto Power On
After losing AC power, the system will not turn on automatically
when power comes back unless you set the Auto Power On jumper
(JP12) to 1-2. Out of safety consideration the default setting on JP12
is 2-3, which avoid system turn on by itself when plug in the power
cole.
JP12 shunt 1-2: Auto Power On feature is On
JP12 shunt 2-3: Auto Power On feature is Off (Default).
BANK 0
(DIMM1)
SDRAM/EDO 8MB, 16MB, 32MB, 64MB, 128MB
BANK 1
(DIMM2)
SDRAM/EDO 8MB, 16MB, 32MB, 64MB, 128MB
Total
System Memory
8MB to Max. 256MB
P6F94 User’s Manual 31
Chapter 2:Hardware Installation
