2. Slide a black plastic support onto each end of the fan or heatsink,
making sure that the hole and clip are on the outside edge of the sup-
port. (If supports are reversed, the holes will not line up with the pegs
on the motherboard.) Slide each support toward the center of the pro-
cessor until the support is seated in the outside groove of the fan
housing.
3. Slide the clip (A) on each support toward the processor, exposing the
hole that will fit over the peg on the motherboard. Push the latches
(B) on the processor toward the center of the processor until they
click into place. (Refer to the figure below.)
4. Hold the processor so that the fan shroud is facing toward the pegs on
the motherboard. Slide the processor (C) into the retention mecha-
nism and slide the supports onto the pegs. Ensure that the pegs on the
motherboard slide into the holes in the heatsink support and that the
alignment notch in the processor fits over the plug in Slot 1. Push the
processor down firmly, with even pressure on both sides of the top,
until it is seated.
P6F94 User’s Manual 27
Chapter 2:Hardware Installation
