33
MAINTENANCE
Regular maintenance is important for optimal per-
formance and to reduce wear. Inspect and properly
tighten all parts each time the incline trainer is used.
Replace any worn parts immediately.
Regularly clean the incline trainer and keep the walk-
ing belt clean and dry. First,
press the power switch
into the off position and unplug the power cord.
Wipe exterior parts of the incline trainer with a damp
cloth and a small amount of mild soap.
IMPORTANT:
Do not spray liquids directly onto the incline
trainer. To avoid damage to the console, keep
liquids away from the console.
Then, thoroughly dry
the incline trainer with a soft towel.
TROUBLESHOOTING
Most incline trainer problems can be solved by
following the steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, please see the back cover of this
manual.
SYMPTOM: The power does not turn on
a.
Make sure that the power cord is plugged into a
properly-grounded outlet (see page 17).
b.
Make sure that the key is inserted into the console.
c.
Check the power
switch located on the
incline trainer near the
power cord. Make sure
that the power switch
is pressed into the on
position.
SYMPTOM: The power turns off during use
a.
Check the power switch located on the incline
trainer near the power cord (see drawing c at the
left). Make sure that the power switch is pressed
into the on position.
b.
Make sure that the power cord is plugged in.
c.
Remove the key from the console, and then
reinsert it.
d. Check the walking belt and the walking platform
for excessive wear. Replace the walking belt or the
walking platform if necessary (see pages 29 to 31).
e.
This may be a symptom of high amp draw.
Lubricate the walking belt if necessary (see
page 31).
f.
If the power still turns off during use, please see
the back cover of this manual.
SYMPTOM: The walking belt is not centered
between the foot rails
a.
IMPORTANT: If the walking belt rubs against
the foot rails, the walking belt may become
damaged. If the walking belt has shifted to the
right:
Remove the key and unplug the power
cord.
Using a 7/32" hex key, turn the roller adjust-
ment screws in the directions shown, 1/4 of a turn
each. Be careful not to overtighten the walking
belt. Then, plug in the power cord, insert the key,
and walk on the incline trainer for a few minutes.
Repeat until the walking belt is centered between
the foot rails.
On
c
Right
a
TROUBLESHOOTING
