30
If you are turning over or replacing the Walking
Platform (23), go to step 5.
If you are replacing only the Walking Belt
(18),
remove the old Walking Belt and discard it.
Next, slide the new Walking Belt onto the Walking
Platform (23). Then, carefully follow steps 1–4 in
reverse order. Make sure to align the Drive Motor
Belt (82) so that it is straight on both pulleys.
Then,
go to step 6.
5.
See drawing 1 on page 29.
Remove the Walking
Belt (18) and the Walking Platform (23) from the
incline trainer.
Check to see whether both sides of the Walking
Platform (23) are worn. If the underside has not pre-
viously been used, turn over the Walking Platform
and continue to use it. If the Walking Platform
has previously been turned over, discard the old
Walking Platform.
Save all other parts.
Using the new Walking Platform (23) or the old
Walking Platform with the unworn side facing
upward, carefully follow steps 1–5 in reverse order.
If you are also replacing the Walking Belt (18), use
the new Walking Belt. Make sure to align the Drive
Motor Belt (82) so that it is straight on both pulleys.
6.
Lift the right or left edge of the Walking Belt (18)
and look for a small arrow printed on the under-
side of the Walking Belt; move the Walking Belt,
if necessary, as you look for an arrow.
If you find
an arrow, make sure that the arrow is pointing
toward the rear of the incline trainer, as shown.
If it is not, remove the Walking Belt, turn it around,
and slide it back onto the Walking Platform (23).
Note: Your walking belt may not have an arrow. If it
does not have an arrow, it can be turned either way.
Next, move the Walking Belt (18), if necessary, until
the seam (not shown) across the Walking Belt is
beneath the Walking Platform (23).
Then, locate the indicated marks on the left and
right sides of the Walking Belt (18). The marks
should be exactly 36" apart.
36
"
18
Arrow
23
6
