14
15. Orient the Front Upright Cover (24) as shown.
Attach the Front Upright Cover (24) around the
Upright (5) by pressing the tabs on the Front
Upright Cover into the Rear Upright Cover (25).
15
16. Make sure that all parts are properly tightened before you use the elliptical. Note: After assembly is com-
pleted, some extra parts may be left over. Place a mat beneath the elliptical to protect the floor.
the receiver included with the heart rate monitor.
17. See steps 15, 14, and 13. Remove the Front
Upright Cover (24), the Console (33), and the
Rear Upright Cover (25) if necessary.
Remove the paper from the adhesive pad on
the back of the Receiver (A). Press the Receiver
onto the indicated location on the inside of the
Rear Upright Cover (25) below the Accessory
Tray (26).
See the inset drawing. Make sure that the
antenna on the Receiver (A) is oriented so
that it is in a horizontal position parallel to
the floor.
Connect the wire on the Receiver (A) to the
Receiver Extension Wire (155).
Next, attach the Rear Upright Cover (25) to the
Upright (5) with four M4 x 19mm Screws (125).
Then,
see steps 14 and 15 and attach the
Console (33) and the Front Upright Cover (24).
Note: Discard any other wires that are included
with the heart rate monitor.
17
25
26
A
A
Antenna
5
25
24
5
125
155
