Freefly MoVI, Руководство пользователя

Страница: 24 / 30

MOUNTING TO A TRIPOD
There are several options for mounting a tripod on the MōVI Controller.
HARDWARE:
MOUNTING PLATES:
HEAT SINK:
TRIPOD ADAPTER PLATE:
There are a series of mounting plates along the front of the controller with 1/4-20 threaded holes. To mount the MōVI Controller to a tripod
using these plates, attach the tripod plate to any of the 1/4-20 threaded holes and rotate the tripod head to the desired angle.
The heat sink located on the back of the controller has a 1/4-20 thread that can be used to mount the MōVI Controller to a tripod when an
IDX plate is not attached.
The M ōVI Controller comes with a tripod mounting plate installed. The tripod mounting plate is attached to the rear mounting plate and has
both 1/4-20 and 3/8-16 tapped holes for mounting to a tripod.
ATTACHING A MONITOR
The M ōVI Controller comes with a Giottos mini ballhead mount and set screw for mounting a monitor. To install a monitor:
Insert the 1/4-20 x 1.25” set screw through the top, center hole of the tripod adapter plate into the mounting plate located on the back of the controller.
Tighten the set screw using a 1/8” or 3mm hex driver.
Make sure the knurled set screw on the Giottos mini ballhead mount is tight, and thread the monitor onto the 1/4-20 thread on the mini ballhead mount.
With the screen attached and the knurled set screw on the Giottos mini ballhead still tight, thread the mini ballhead mount onto the 1/4-20 set screw until tight.
To adjust the screen position, loosen the knurled set screw and rotate the mini ballhead housing and adjust the monitor angle until the monitor is in the correct orientation.
Tighten knurled set screw to lock monitor in place.
+
+
+
+
+
+