FP FPi2000, Руководство оператора, Страница: 13 / 26

13
ENGLIS
H
Envelope insert fingers
To adjust the insert fingers A (see figure above)
loosen the knurled knob C on top of each finger.
Adjust each finger so that the tip enters about 5
mm (0.2 inch) into the envelope. Re-tighten the
knurled knob. The fingers can be moved
sideways to the desired position. Place the outer
fingers D about 5 to 10 mm (0.2 to 0.4 inch) from
the edges of the envelope.
Check the position of the insert fingers when
changing to a different type of envelope.
3.11 Fill & Start
Before starting the Fill & Start function (see
figure below) the adjustment of the side guides
and envelope separation must be made
manually to obtain correct operation.
The address carrier must be put into the upper
feeder.
Only the address position can be adjusted if
needed.
Testset
Press key 2 to start a testset in the Fill & Start
screen. The settings of the testset will be saved.
Only the feeders that feed successfully will be
selected.
If needed adjust the address position.
In the Fill & Start job the following options
cannot be used:
• feeder swap (the system switches
automatically to the upper feeder when the
lower feeder is empty and vice versa),
• multifeed (more sheets are fed from the same
feeder into the envelope),
• the use of the Fill & Start function is not
possible in the "no envelopes" mode.
4. JOB PROGRAMMING
4.1 Job menu
After pressing key 3 in the "main menu (2)", the
display shows the "job access" menu and asks
for a pin code (2324) to enter (see figure below).
4.2 Job menu (1)
The job menu (1) shows the following functions
(see figure below):
Press and hold key 1 to show the job info.
To go back to the main menu (1) press "esc".
4.3 Create job
Only free jobs will be shown. The "create job"
menu shows the following functions.
• job information ( ),
• choose a higher job number,
• choose a lower job number,
• select the job to create and confirm with "OK"
which will get you to the "job settings" menu
(1).
If all jobs are used the display shows "no more
free jobs".
To get a free job one has to be deleted.
A new selected job number starts with default
settings.
4.4 Edit job
Only programmed jobs will be shown. This
menu shows the following functions:
• job information ( ),