Foxtech NAGA PRO, Руководство пользователя

Страница: 73 / 75

NAGA PRO User Manual
69
Cause of the problem:
This may be a hardware problem, or it may be that flight controller is
started immediately after flashing the firmware.
Solution: Re-power on the flight controller and reconnect it.
17. Gyros not healthy
The cause of the problem:
the data of the gyroscope fluctuates badly, the value is out of
range, and there is no data. This may also be a hardware problem, or it is not static when it is
powered on, resulting in an error.
Solution: lay it flat and turn on the power again.
18. Gyro cal failed
The cause of the problem:
usually when the power is turned on (when the red and blue lights
are flashing, the power is cut off. Or the value exceeds the peak value will also cause this error
message.)
Solution: Re-level and power on.
19. Gyros inconsistent
The cause of the problem:
The rotation rate of the two gyroscopes differs by more than 20
degrees/sec. This may be a hardware failure or the gyroscope is calibrated incorrectly.
Solution: Power on again
20. Check FS_THR_VALUE
The cause of the problem:
The current throttle value is too low and the failsafe protection has
been triggered.
Solution:
Check the throttle channel setting of the remote controller. The normal value should
not be lower than 1000. The most suitable value is around 1100. Check the ground
station-Failsafe setting-whether the throttle value is set too high.
21. Fail to ARM and Solution
- Flight controller failure or non-calibration: Check the error report in the flight data menu
in the ground control station. Resolve according to the error message. If you want to unlock
successfully, the flight controller cannot report any errors. If the accelerometer and
geomagnetism are not calibrated, the flight data will show a response failure.
-
Incorrect forward or reverse phase: the flight controller will check the throttle and rudder
when unlocked. The direction of lifting in the ground control station is opposite to the
direction of your remote controller (for example, the remote controller lifting channel is down,