101364
Model
FT2
4.1.2.
Entering the Programming Mode
To enter the programming mode, press the
F1
or
F2
key repeatedly in the normal running mode
until the following screen is shown:
SET PARAMETERS ?
No Yes
F1
F2
F3
F4
Press
YES (F4)
and the following screen will prompt the user to enter the password if it is active:
PASWD:_
UP DN NXT OK
F1
F2
F3
F4
Enter the correct password, follow the instructions for changing a value as specified in section
4.1.1. The default Level 1 password is “1234”.
If the wrong password is entered, the message “Wrong Password” will be displayed for a few
seconds and then returns to the programming entry screen.
If the password is accepted, the following screen will be shown:
SET PARAMETERS
I/O FLO DSP EXIT
F1
F2
F3
F4
This is the base screen for the programming mode.
Press
EXIT (F4)
repeatedly until “Normal Mode” is seen briefly to exit the programming
mode.
4.1.3.
Analog 4-20 mA Output
The following menu allows the scaling of the analog 4-20 mA outputs.
From the base screen, press
I/O (F1)
and
then in the next screen press
420 (F3)
.
SET I/O
I/O FEQ 420 EXIT
F1
F2
F3
F4
Fox Thermal Instruments Inc., 399 Reservation Road, Marina, CA 93933
Page 29
