Model FT2
101364
These are the selections for the display #1 line #1.
Selections are:
Flo rate for Flow rate
Flo Total for Total mass
Elps time for elapsed time
Temp
for
temperature
Errors for error codes
When the selection is correct, press
OK (F4)
to accept it and then the display will go
through the same process for all 4 lines of the 2 programmable displays (DSP1L1,
DSP1L2, DSP2L1 and DSP2L2).
After the last line of display 2 is accepted, the display will show the following menu:
This menu allows you to alternate between menu display 1 and 2 every few seconds.
Selections are: On or Off
Press
OK (F4)
to accept selection.
Press
EXIT (F4)
repeatedly until “Normal Mode” is seen briefly to exit the programming
mode.
ALTERNATE = Off
NXT OK
F1
F2
F3
F4
4.1.8.
Password
There are 2 user level passwords, only
Level 1
is programmable and gives access to all the normal
settings. The second one is used to allow access to calibration factors, that should normally never
be changed, and to set a new password in the event that the user forgets the
Level 1
password.
Default
Level 1
password is “1234”, and
Level 2
password is “9111”.
The
Level 1
programmable password can be disabled by setting it to “0”.
From the base programming menu press
DSP (F3)
to select the display menu:
DISPLAY/PASSWORD
DSP PSW EXIT
F1
F2
F3
F4
Page 36
Fox Thermal Instruments, Inc., 399 Reservation Road, Marina, CA 93933
