Fox F31-462A, Инструкция по эксплуатации

Страница: 14 / 32

14
belt and disc, as well as the piece you are working against the disc or belt.
It is advisable to check the engine, its ventilation system and air routes. Check the condition of the cruise control, the
tension of the band and the material to be ground. Properly maintain the workpiece.
The quoted values are emission values calculated using standard values and are not representative of use within the
workplace. Although there is a correlation between levels of emission, it is impossible to draw any conclusions about
extra precautions to make. Factors with potential influence on the sound level at the place of work include working
time, the size of the room and other noise sources (eg the number of machines in operation, other noisy operations
performed at the same time). Noise thresholds vary from one country to another. However, these instructions allow
the machine user to better assess the dangers and risks.
UNPACKING AND CLEANING
Your new belt sander and disc comes complete in a box. Unpack it carefully and make sure that
nothing is missing and there are no damaged parts. Do not throw away the box until the
machine has been checked carefully, all parts identified, and you have used the device to
satisfy yourself that it is fully functional.
If parts are damaged or missing, do not plug the sander and do not turn the switch to the "on" position so as not to
compromise the effectiveness and safety of the tool. Contact an authorised service centre for replacement of
defective or missing parts.
To make the sander fully operational, install the parts as described in the following paragraph.
Please read the installation instructions and follow them carefully.
Figure 2 illustrates the sander and all spare parts supplied with the machine.
Remove the protective coating from all parts that are not painted. This protective coating can be removed with a soft
cloth moistened with WD40. Do not use acetone, gasoline or paint thinner.
List of parts supplied:
• Self-adhesive sanding disc
• Disc housing
• Phillips Screws (2)
• Mounting screws M8x12 (2)
• Washers (2)
• Tab Guide
• Hex key • Work Table
• Backstop