Fox F31-462A, Инструкция по эксплуатации

Страница: 24 / 32

24
SANDING A CURVED PIECE
Figures 18 and 19
Sanding a concave surface on the sanding belt :
Always sand a concave surface on the free drum as shown in
Figure 18.
• Hold the piece being sanded, being careful to keep your fingers
away from the sanding belt.
• Hold the end of the piece firmly in contact with the support
plate, and move the piece to consistently use the full width of the
sanding belt.
Note : work very carefully when sanding a thin piece. Apply just
enough pressure to the sanding belt to sand the material.
CAUTION :
A severe recoil can occur when pressing the piece
to the sanding disc. Failure to observe this warning may
result in serious injury.
Sanding a convex surface on the sanding disc :
Always use the sanding disc for sanding a convex surface; move
the piece being sanded on the left toward the center of the disc
as shown in Figure 19.
• Hold the piece being sanded, being careful to keep your fingers
away from the sanding belt.
• Hold the end of the piece firmly in contact with the support
plate, and move the piece to consistently use the full width of the
sanding belt.
WATCH OUT :
Never attempt to sand the end surfaces of a piece on the free drum; this
could cause pieces to shear off. Ignoring this warning may result in
serious injury.