Fox F31-462A, Инструкция по эксплуатации

Страница: 22 / 32

22
ANGLE BETWEEN THE TABLE AND SANDING
DISC
Figure 12
• Unplug the machine.
• Using a bracket (not included), check the angle between
the worktable and sanding disc.
• If the angle is not exactly 90°, loosen the table lock knob
and tilt the table.
• Adjust the angle between the worktable and sanding
disc, and tighten the lock button.
• Loosen the screw of the angle indicator, align the 0° and
tighten the screw.
Note
: Use the adjustment screw located below the
worktable to adjust the distance between the table and
the sanding disc.
OPERATION
ON / OFF SWITCH
 Start = press the green button.
 Stop = press the red button.
In case of power failure, the machine stops and is
prevented from automatically restarting itself when the
power is restored. To reboot the machine, press the green
button.
SANDING A BEVEL
Figure 14
It is possible to tilt the work table between 0° and 45° for
grinding a bevelled piece. To tilt the working table:
• Loosen the table lock knob (turn anticlockwise).
• Position the work table to the desired angle.
• Note: Position the work table within no more than 1.6mm
of the sanding surface.
• Tighten the table lock knob (turn clockwise).