Fostex DV-40, Руководство по эксплуатации

Страница: 42 / 182

4-6
To check the recorded audio file after recording, follow the procedure below.
Playback of recorded audio
1. While holding down the [STOP] key, press the [REWIND] key.
The unit immediately locates to the beginning of the audio file (ABS 0).
2. Press the [PLAY] key to start playback from the beginning of the audio file.
3. Monitor the playback audio via headphones or a monitor system.
If the analog outputs are connected to a mixing console, adjust the monitor level using the control of
the console. When the playback position reaches to the end of the audio file, the unit automatically
stops. If you are not satisfied with the recorded result, you can undo the recording by the procedure
described in
"Undo function"
below.
Multiple-undo function
To undo recording, use the multiple-undo function.
Y M D H M S
2
1
-INT-
BWF
FORMAT
CLOCK
-0.1%
kHz
48
24
FS
BIT
DATE
∞
60 50 42 34 28 2018 12 8 6 5 4 3 2 1 0 OL
2. Select the desired event from the history using the [JOG] dial (or the [SKIP/CURSOR] |<</>>| keys),
and press the [ENTER/YES] key.
After the first take has been completed, if you wish to return to the condition before recording, select
the date/time when the file was created.
"Multi Undo!"
appears for a short time on the display, followed by
"Undo Completed!"
, showing that the
undo operation is completed. The display changes to show the beginning of the audio file.
Flashing
<Notes for performing the multiple-undo function>
• You cannot undo recording on a
"Tape mode"
audio file.
• The ending date/time of each take is memorized based on the internal clock, therefore, it is important to
adjust the date/time of the internal clock correctly.
• The unit keeps all takes on the disk in order to make the multiple-undo function for all takes of the current
audio file possible, therefore, the remaining disk space gets smaller each time you record another take.
To release the unnecessary take history (= undo file), use the
“Release Undo File?”
menu in the Utility mode.
See
“Chapter 12: Utility mode”
for details.
1. Press the [UNDO] key.
The display changes to show
"Select History?"
, as below.
The history keeps the date/time when the file was created and the ending date/time of each
recording take.
Tips:
The history of takes starts by the date/time when the file was created, followed by the ending date/time of each
recording take, as illustrated below. By selecting the desired history event and performing the undo function,
you can recall the desired take.
Tips:
After the audio file is recorded in the NEW FILE mode, you can overwrite the file or make recording following
the end of the file. See page 4-8 for details about the INSERT mode.
date/time when
the file created
Time
date/time of
take-1 end point
date/time of
take-2 end point
date/time of
take-3 end point
date/time of
take-4 end point