Model 8335 (TC/SYNC card) Owner's Manual
17
Recording
1
. Set the D-15 front panel [
CLOCK
] switch to [
INT
].
When an external sync signal is input as a reference to record the time
code in sync with this sync signal, set the [
CLOCK
] switch to [
EXT
] using
the SETUP menu "503 -***.” Set it to the external clock identical with the
external sync signal (Refer to
<
NOTE
> below).
Refer to page [15] for setup of the SETUP menu "503 -***."
2
. Setup the frame rate by the SETUP menu "
411 -***
" when time code to be
recorded is
29.97
fps or
30
fps.
When recording the 24fps, 25fps time codes, they will be automatically
acknowledged and recorded regardless to the setting of the SETUP menu.
The D-15 will automatically acknowledge 24 and 25fps time codes
and record them but 29.97 and 30fps cannot be acknowledged.
Therefore, if 29.97 or 30fps time codes are to be recorded, they
must be specified by the SETUP menu "411 -***."
Refer to page [13] for setting by the SETUP menu "411-***."
3
. Start the externally connected audio equipment and the TC generator.
4
. Start the D-15 in the record mode by pressing the [
PLAY
] button while
pressing the [
RECORD
] button.
5
. After completing the recording, press the [
STOP
] button.
<NOTE>
Because ASSEMBLE recording only can be made by the D-15, if recording is
temporarily stopped and then resumed, continuous time code cannot be
recorded.
<NOTE>
If a recording is made with the [CLOCK] switch at [INT], a slight deviation of the
clock will be created between the recorded time code (LTC) and the inner
sampling clock.
In such a case, synchronize the entire system by input of an external video sync
signal as a reference to the VIDEO IN connector of this equipment.
