Model 8335 (TC/SYNC card) Owner's Manual
14
8. Setup of the CHASE operation mode [CH SE M od 501 -***]
The mode for locking (chase locking) D-15 to the external time code is selected
by this menu. Operating modes can be selected from "oncE," "Cont" or
"FrAME."
After entering the SETUP mode, rotate the [
JOG
] dial, select the [
CHSEMod
501 -***
] menu, and press the [
EXECUTE/SET
] key. Then, after rotating the
[
JOG
] dial CW and CCW to select the desired frame rate, press the [
EXECUTE/
SET
] key again (* is the initial setting).
This setup content will be held even if the power is switched OFF.
Functional note
Menu No.
Setup No.
Functional content
oncE
501
000 (*)
After CHASE ON of D-15, chase is ended
upon locking once on REF TC, then D-15
will free run. Also, even if lock is
disengaged, it will not enter chase again.
Cont
501
001
After CHASE ON of D-15, it will lock onto
REF TC, then will free run.
If lock is disengaged, it will automatically
chase again.
FrAME
501
002
After CHASE ON of D-15, it will lock on to
REF TC and frame sync playback
executed at a sufficiently low fluctuation
variable speed playback on the hearing
characteristics such that it will remain
locked (Refer to <NOTE>) .
Should lock be disengaged, it will auto-
matically chase again.
When the audio sampling clock and the time code clock do not match,
the lock is apt to become disengaged if the transport is run for a long
time. In such a case, use the above "FrAME (002)" mode.
<NOTE>
Permissible clock deviation between external time code and chaseable clock is
about 0.1 %. Therefore, it will not function if clock deviation is larger than this.
9. Setup of the lock window [Lo ck Wi nd 502 -***]
The reference frame to determine the UNLOCK state subsequent to CHASE
locking when selecting the "Cont (continue)" or "FrAME" CHASE operation
mode to make the D-15 CHASE by the external time code, is selected by this
menu. The reference frames can be setup within the one to 20 frame range
in one frame units.
After entering the SETUP mode, rotate the [
JOG
] dial, select the [
LockWind
502 -***
] menu, and press the [
EXECUTE/SET
] key. Then, after rotating the
[
JOG
] dial CW and CCW to select the desired frame rate, press the [
EXECUTE/
SET
] key again (* is the initial setting).
This setup content will be held even if the power is switched OFF.
Functional note
Menu No.
Setup No.
Functional content
1 FrAM
502
000
The 1~20 frames can be set in one frame
steps.
20 FrAM
502
020
(*) "010" = 10 frames.
